Epson Equity 486DX2/50 PLUS User Manual - Page 127
jumpers on the slave drive., Set the jumpers according to the table below.
View all Epson Equity 486DX2/50 PLUS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
Set the jumpers according to the table below. Hard disk drive jumper settings X = jumper installed - = no jumper installed To move a jumper from one position to the other, use your fingers, needle-nose pliers, or tweezers to pull it off its pins and gently move it to the other position. Be careful not to drop the jumper or damage the pins as you install it. If you are going to use only one hard disk drive, make sure the jumper is set in position DS. If you'll be using two hard disk drives, install two jumpers on the master drive in positions SP and DS. Do not install any jumpers on the slave drive. To install or remove a drive in the internal drive bay, see page 7-14. To install or remove a drive in the external drive bay, see the next section. Installing and Removing Drives 7-5