Epson Equity 486DX2/50 PLUS User Manual - Page 67

If you want to save the settings you entered, highlight ** EXIT AND SAVE ** and press m at a Setup summary screen. The Setup program stores the new settings and resets the computer using the new configuration. If you have set a password, you need to enter it at the key prompt. (See "Using a Power-on Password" in Chapter 3 for instructions.) The Operation Menu appears. If you have just run Setup for the first time, remove the Reference diskette from the drive and turn off your computer. Then follow the instructions in your MS-DOS manual to install the operating system. (If you are using a different operating system, follow the installation instructions in that manual.) Once you have installed MS-DOS, you should always boot the computer from the hard disk or the MS-DOS Startup diskette when you are finished running Setup. First remove the Reference diskette from drive A. If you do not have a hard disk, insert the Startup diskette. Then reset your computer to make sure it performs all the commands in the CONFIG.SYS and AUTOEXEC.BAT files. If the computer displays an error message while it is starting up, run the Setup program again and check the setting the error message indicates. If the computer still displays an error message after you check your Setup program settings, see Appendix B or C, or ask your dealer for assistance. Be sure to make a backup copy of your Reference diskette Running the Setup Program 2-33