Epson Equity 486DX2/50 PLUS User Manual - Page 30
After you connect a mouse, you may need to add, commands to your MS-DOS CONFIG.SYS file to enable
View all Epson Equity 486DX2/50 PLUS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Follow these steps to connect a mouse: 1. Make sure the computer is turned off. 2. Hold the mouse connector so it is oriented properly with its port (marked with a mouse icon). Insert the connector as shown below. interchangeably. Be sure to plug the mouse only into the 3. After you connect a mouse, you may need to add commands to your MS-DOS CONFIG.SYS file to enable your computer to use it. See your MS-DOS and mouse manuals for instructions. 1-12 Setting Up Your System
Follow these steps to connect a mouse:
1.
Make sure the computer is turned off.
2.
Hold the mouse connector so it is oriented properly with its
port (marked with a mouse icon). Insert the connector as
shown below.
interchangeably. Be sure to plug the mouse only into the
3.
After you connect a mouse, you may need to add
commands to your MS-DOS CONFIG.SYS file to enable
your computer to use it. See your MS-DOS and mouse
manuals for instructions.
1-12
Setting Up Your System