Gateway E-9510T Gateway 9510 Server User Guide - Page 18
Tools required, To convert your server to rackmount configuration
View all Gateway E-9510T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Tools required The following tools are required to make the conversion: ■ Phillips head screwdriver (#2) ■ Straight blade screwdriver ■ Anti-static wrist strap (recommended) Setting up the hardware Warning Lifting the server and attaching it to the rack is a two-person job. If needed, use an appropriate lifting device. A fully loaded Gateway 9510 server weighs about 80 lbs (36.2 kg). To convert your server to rackmount configuration: 1 Follow the instructions in "Preventing static electricity discharge" on page 41. 2 Follow the instructions in "Opening the server case" on page 42. 3 Follow the instructions in "Removing the bezel assembly" on page 44. 4 Remove the two screws on the back of the chassis that secure the top cover to the chassis. Screw 5 Slide the top cover back about two inches, then remove it from the chassis. 6 Remove the chassis feet from the bottom of the server. www.gateway.com 13