Gateway E-9510T Gateway 9510 Server User Guide - Page 85
it firmly into the socket. The tabs on the sides of the DIMM socket should secure
View all Gateway E-9510T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Chapter 4: Installing Components 6 Insert the activation key into its socket on the system board (see "System board" on page 7 for the location of the socket.) Push it into the socket until it is below the two retaining clips. 7 Pull the plastic tabs away from the sides of the DIMM socket. If you are replacing a DIMM, remove the old one. 8 Holding the DIMM (or portable cache module with battery) by the edges, align the notch on the bottom edge of the DIMM with the notch in the DIMM socket and press it firmly into the socket. The tabs on the sides of the DIMM socket should secure the DIMM automatically. 9 Replace the PCI expansion card in PCI slot 1 (if removed) by following the instructions in "Installing PCI expansion cards" on page 69. 10 Follow the instructions in "Installing the air ducts" on page 47. 11 Follow the instructions in "Closing the server case" on page 52. 12 Configure the BIOS settings to enable the ROMB option. 80 www.gateway.com