Gateway E-9510T Gateway 9510 Server User Guide - Page 55
Rotate the bezel assembly toward the chassis until the two plastic tabs on the left side
View all Gateway E-9510T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Chapter 4: Installing Components 2 Close the bezel door. 3 With the bezel assembly at a 40 degree angle from the chassis, engage the three bezel retention hooks on the right side of the bezel assembly with the raised metal slots in the right front edge of the chassis. Caution If the bezel assembly is angled at more than 40 degrees from the chassis, you may damage or break off the retention hooks on the right side of the bezel assembly. 40˚ Max 4 Rotate the bezel assembly toward the chassis until the two plastic tabs on the left side of the bezel assembly snap into place. 5 Relock the bezel, if required. 50 www.gateway.com
50
www.gateway.com
Chapter 4: Installing Components
2
Close the bezel door.
3
With the bezel assembly at a 40 degree angle from the chassis, engage the three bezel
retention hooks on the right side of the bezel assembly with the raised metal slots in
the right front edge of the chassis.
4
Rotate the bezel assembly toward the chassis until the two plastic tabs on the left side
of the bezel assembly snap into place.
5
Relock the bezel, if required.
Caution
If the bezel assembly is angled at more than 40 degrees from the
chassis, you may damage or break off the retention hooks on the right
side of the bezel assembly.
40
˚
Max