Gateway E-9510T Gateway 9510 Server User Guide - Page 59

Chapter 4: Installing Components ■ IDE drives can be configured as master, slave, or cable-select. ■ If cable-select is available (drive assignments will be marked on the cable), the IDE cable assigns the master/slave positions to the drives it connects. You can override these assignments using the jumpers on the drives. ■ If cable-select is not available and only one drive is attached to an IDE controller cable, configure the drive as master if it is a CD or DVD drive. If two drives of any type are attached to the cable, configure one as master and one as slave. ■ You may need to configure the drives you install using the BIOS Setup utility. Press F2 at startup to open the BIOS Setup utility. Installing or replacing a fixed, removable-media drive Use these instructions to install or replace a diskette, CD, DVD, or tape drive. To install a 5.25-inch drive: 1 Follow the instructions in "Preventing static electricity discharge" on page 41. 2 Follow the instructions in "Opening the server case" on page 42. 3 Follow the instructions in "Removing the bezel assembly" on page 44. 4 If you are replacing a drive, go to Step 8. - OR If you are adding a new drive to an available 5.25-inch device bay, remove the slide/filler panel assembly from the bay by pressing and holding the two locking clips inward, then pulling the assembly out of the bay. 5 Remove the drive rails from the filler panel assembly. 54 www.gateway.com