Gateway E-9510T Gateway 9510 Server User Guide - Page 86

Replacing a power supply module Replacing a power supply module Your server uses hot-swappable, redundant power supplies. If one of the two power supplies fails, the other power supply module supports the server while you replace the failed module. You do not need to turn off the server or disconnect peripheral devices to replace a failed power supply module. If you are adding a redundant power supply module to your server, you must update the FRU/SDR after the installation is complete. For more information, see "Updating the FRU/SDR" on page 37. Warning The power supply modules in this server contain no user-serviceable parts. Only a qualified computer technician should service the power supply modules. Your server comes with 3-wire AC power cords fitted with the correct plug style for your region. If this plug does not match the connector on your surge protector, UPS, or wall outlet, do not attempt to modify the plug in any way. Use a UPS or wall outlet that is appropriate for the supplied AC power cords. To replace a power supply module: 1 Examine the LED indicators on the back of each power supply module to identify the failed module. The power supply module has failed if the orange (right) LED indicator is on. Shipping screw Power on LED Power supply fault LED 2 Unplug the power cord from the failed power supply module. 3 Remove the shipping screw (if installed). www.gateway.com 81