HP LaserJet 1010 Service Manual - Page 83
Removing the transfer roller 2 of 3
View all HP LaserJet 1010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
3. The clamps on the paper guide fit over the bearings on the right and left ends of the transfer roller. Do not touch the sponge part of the transfer roller, but grasp the right end of the paper guide (callout 1, figure 5-18) and pull the clamp off the right bearing. Then slide it slightly to the right, and the left clamp will slide off the left bearing. Figure 5-18. Removing the transfer roller (2 of 3) ENWW Internal assemblies 71
3.
The clamps on the paper guide fit over the bearings on the right and left ends of the
transfer roller. Do not touch the sponge part of the transfer roller, but grasp the right end
of the paper guide (callout 1, figure 5-18) and pull the clamp off the right bearing. Then
slide it slightly to the right, and the left clamp will slide off the left bearing.
Figure 5-18.
Removing the transfer roller (2 of 3)
ENWW
Internal assemblies
71