HP LaserJet 1010 Service Manual - Page 98
Control Panel s, Control Panel s: Time Ranges
View all HP LaserJet 1010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
Control Panel Pages When the printer is in the ready state, pressing the Go button for varying amounts of time accesses important printer reports. The general procedure for initiating the power on actions is as follows (refer to the table for specific time ranges for each action): 1. Ensure that only the Ready light is on. 2. Press and hold the Go button. 3. Release the Go button after the amount of time shown in the table for the desired output. Control Panel Pages: Time Ranges Control Panel Page Demo Page Configuration Report Cleaning Page Time-Range (seconds) Light Status Release Go after 0 to 4 Ready: Blinks seconds. Release Go after 5 to 9 Go: ON seconds. Release Go after 10 seconds. Go: ON Attention: ON Ready: ON Results and Notes Printer outputs a demo page. Printer outputs a configuration report. The printer will run through a cleaning cycle using the loaded media. Best cleaning results when using a transparency as media. 86 Chapter 6 Troubleshooting ENWW