HP LaserJet Enterprise P3015 HP LaserJet P3010 Series - Software Technical Ref - Page 201
Setting up a printer with Mac OS X v10.3.9, Nearest Size & Scale
View all HP LaserJet Enterprise P3015 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 201 highlights
d. On the first configuration page, under IPv4, find the IP Address. Type this address into the Address field on the add printer screen. e. The Name, Location, and Print Using information will automatically be filled in. If the product PPD does not appear in the Print Using field, turn the computer off and then on again and restart the setup process. 6. Select the product and click Add. The Installable Options screen appears. 7. In the Optional Trays: drop-down menu, select the trays that are installed on the product. 8. In the Collation in Printer: drop-down menu, select the amount of memory and hard disk combination that is installed in the product: 9. If the product has a hard disk, select Installed from the Printer Hard Disk drop-down menu. 10. If the product has a duplex unit, select the Duplex Unit check box. 11. In the Accessory Output Bins: drop-down menu, select the output bins that are installed on the product. 12. In the Paper Matching: drop-down menu, select one of the following options: ● Prompt User for correct size ● Nearest Size & Scale ● Nearest Size & Crop 13. After you have selected the settings in the Installable Options screen, click Continue. The product name appears in the Printer List and the setup is complete. Setting up a printer with Mac OS X v10.3.9 Complete these steps after completing the printing-system software installation. 1. If you are installing the product using a USB connection, connect the USB cable between the product and the computer. Turn on the product. If you are installing using a network connection, verify that the network cable is connected to the product and that the product is on. 2. In the Applications folder, open the Utilities folder, and then run the Printer Setup Utility. 3. If you are installing the product using a USB connection, verify that the product appears in the printer list. The Kind column in the printer list same change as before should display the product name. If this is the case, the setup is complete. If the product does not appear, or if the correct information does not appear in the Kind field, see Troubleshooting the product setup on page 185. If you are installing the product using a network connection, continue with the following steps. 4. Click Add and then click Add to open the add printer screen. 5. Select the network connection protocol in the top pull-down menu. The two supported protocols are Rendezvous and IP Printing. NOTE: Rendezvous is the easiest method and is the best method to use if the product is installed on your local network. IP Printing must be used if you are installing the product on a different network. Macintosh ENWW Macintosh install and uninstall instructions 183