HP ML530 ProLiant ML530 Generation 2 Server Setup and Installation Guide - Page 109
SCSI Devices in the Removable Media Bay or Cabling IDE Devices in the, LEDs, see Appendix C
UPC - 720591250669
View all HP ML530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
Installing Hardware Options 9. Slide the device into the removable media drive bay until the release latch locks into place. Figure 3-51: Installing a SCSI or IDE device in the removable media bays (tower model) 10. Cable the power and signal cables for your SCSI or IDE device. See "Cabling SCSI Devices in the Removable Media Bay" or "Cabling IDE Devices in the Removable Media Bay" in this chapter. 11. Reinstall the access panel. 12. If you have a tower-model server, close the front bezel door. 13. Install the server. See Chapter 5, "Installing the Rack Server" or Chapter 6, "Installing the Tower Server." 14. Power up the server. See Chapter 5, "Installing the Rack Server" or Chapter 6, "Installing the Tower Server." 15. Be sure that the LED on the front of the SCSI or IDE device is illuminated green, indicating that the system is functioning properly. For detailed information on LEDs, see Appendix C, "System LEDs and Switches." 16. If any of the LEDs indicates an error, see Appendix D, "Troubleshooting," or refer to the troubleshooting guide for instructions. For more information about installing and configuring SCSI or IDE devices in the removable media bays, refer to the documentation that ships with the option kit. HP ProLiant ML530 Generation 2 Server Setup and Installation Guide 3-63