HP ML530 ProLiant ML530 Generation 2 Server Setup and Installation Guide - Page 87
Power up the server. See Server Configuration and Utilities., Cabling the Server.
UPC - 720591250669
View all HP ML530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
Installing Hardware Options 10. Close the PCI retaining clip (for full-length expansion boards only). Figure 3-32: Securing the PCI retaining clip NOTE: If you are installing a Remote Insight board, you must cable the expansion board to the system board. See "Remote Insight Board" in this chapter. 11. Install the access panel. 12. Install the server. See Chapter 5, "Installing the Rack Server" or Chapter 6, "Installing the Tower Server." 13. Cable the server. See Chapter 7, "Cabling the Server." 14. Power up the server. See Chapter 8, "Server Configuration and Utilities." 15. Be sure that the internal health LED on the front panel LED assembly is illuminated green, indicating that the system is functioning properly. For detailed information on LEDs, see Appendix C, "System LEDs and Switches." 16. If the LED indicates an error, see Appendix D, "Troubleshooting," or refer to the troubleshooting guide for instructions. HP ProLiant ML530 Generation 2 Server Setup and Installation Guide 3-41