HP ML530 ProLiant ML530 Generation 2 Server Setup and Installation Guide - Page 58
Opening the Hot-Plug Door, to lock the server into the fully extended position
UPC - 720591250669
View all HP ML530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Installing Hardware Options Opening the Hot-Plug Door To open the hot-plug door: 1. For tower-model servers only, lock the casters at the base of the server and gently tilt the server onto the side opposite the access panel to facilitate access to internal components. 2. For rack-model servers already installed in a rack, complete the following steps to lock the server into the fully extended position: a. Loosen the front panel thumbscrews to release the server from the rack. b. Extend the server from rack until it stops. 3. Locate the hot-plug door key. The key is located inside the front bezel door on tower-model servers (1), or in a bag attached to the rear handle on rack-model servers (2). Figure 3-7: Locating the hot-plug door key 3-12 HP ProLiant ML530 Generation 2 Server Setup and Installation Guide