HP Media Center m7200 HP Media Center PC Getting Started Guide - Page 17
Using the Analog Video Cable, Refer to the S, guide for more, information about the, various display
View all HP Media Center m7200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Using the Analog Video Cable (Select models only) D E If you are using the analog video cable to connect your PC display to your PC, you need to connect the cable and then set the Output switch on the cable to match the correct video output. If you are using component cables, you must also set the resolution of your TV or other video display on the analog video cable. To use the analog video cable: 1 Make sure the PC power is disconnected. 2 Connect the analog video cable to the Analog Video Output connector on the back of the PC. 3 If you are using a composite or S-video cable to connect your display to the PC, set the switch labeled Output near the arrows toward the S-video and composite (A) connectors. See (D) above. Go to step 7. Analog Video 4 If you are using Component video cables to connect your display to the PC, set the switch labeled Output near the arrows toward the three (Y, Pb, and Pr) component connectors (B). See (E) above. Go to step 5. B n Refer to the Start Here guide for more information about the various display connection options. A 5 Check the documentation for your display to find out the optimal resolution. Connecting the Television Signal 13