HP Media Center m7200 HP Media Center PC Getting Started Guide - Page 20
Connecting the Remote Sensor, end of the cable over the remote infrared IR
View all HP Media Center m7200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Connecting the Remote Sensor The remote sensor is a small device that connects to the PC and allows the remote control to work with the Media Center program. 1 If you have a cable TV set-top box, a satellite set-top box, or other set-top box that controls your TV signal, connect the remote control sensor cable (emitter) (A) into connector (1) on the back of the remote sensor. 2 Remove the paper from the backing tape on the end of the cable (B), and then press the end of the cable over the remote infrared (IR) receiver window on your cable TV set-top box (C). 3 Plug the remote control sensor cable into a USB connector (D) on the back of the PC. 4 Place the remote sensor so that you can easily point at it with the remote control. (An ideal spot would be on top of the monitor or desk.) P C 21 A B D 16 HP Media Center PC Getting Started Guide