HP StorageWorks 8/80 Brocade Access Gateway Administrator's Guide v6.2.0 (53-1 - Page 76
TABLE 12, you run
View all HP StorageWorks 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
A Troubleshooting TABLE 12 Problem Troubleshooting (Continued) Cause Failover is not working Failover disabled on N_Port. Access Gateway is mode Access Gateway must be disabled. not wanted Solution Verify that failover and failback policies are enabled, as follows: Enter the ag --failoverShow command with the operand. Enter the ag --failbackShow command with the operand. Command returns "Failback (or Failover) on N_Port is supported." If it returns, "Failback (or Failover) on N_Port is not supported." See "Adding a preferred secondary N_Port" on page 52. Disable switch using the switchDisable command. Disable Access Gateway mode using the ag --modeDisable command. Answer yes when prompted; the switch reboots. Log in to the switch. Display the switch settings using the switchShow command. Verify that the field switchMode displays Fabric OS native mode. NOTE If a Fabric OS switch is in Access Gateway mode and is also set to McDATA Fabric mode, when that switch is connected to an M-EOS switch, the Fabric OS switch does not display in the output when you run the agshow command. 58 Access Gateway Administrator's Guide 53-1001189-01