HP Surestore 28/48-Slot with DLT7000 Digital Linear Tape SCSI-2 Drive and SCSI - Page 149
Fibre Channel Status Rev 1 Format, Device # SCSI speed
View all HP Surestore 28/48-Slot with DLT7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 149 highlights
Library SCSI-3 Command Set Read Buffer Command (3CH) Table 2-82 Fibre Channel Status (Rev 1 Format) Byte 7 6 5 4 3 2 1 0 n+29 Additional length n = (N * 24) + 11 IPMB Message status: See Table 2-68 on page 2-87. Board status: Current status of the controller board. See Table 2-69 on page 2-88. Board type: The type of controller (11, 12 = fibre). See Table 2-70 on page 2-88. Been Setup: Set if the controller has been given its setup variables. Format rev: 0 = The report format with 14 bytes per target device. Used on code revisions below 1.20x 1 = The report format with 24 bytes per target device. Single sourced: Set if the controller is single sourced. Controller number: Controller number of the above type (i.e., controller 1 of type fibre). Device valid: 1 = information in Device fields are valid; 0 = not valid. Addr valid: 1 = information in link address is valid; 0 = not valid. WWN valid: 1 = information in Worldwide Names is valid; 0 = not valid. LVD/HVD: 1 = Low voltage differential board; 0 = High voltage differential board. # SCSI device entries to follow: Specifies the number of device entries following. Device entry length: Format revision 1 has a device length of 24 bytes per target device. Data format revision: 0 = initial revision of format rev 1. Bus #: 1 = SCSI bus 1; 2 = SCSI bus 2. Device # SCSI width: The device's negotiated SCSI width. 0 = unknown; 1 = 8 bits; 2 = 16 bits. Device # SCSI speed: The device's negotiated SCSI speed. 0 = async; 1 Chapter 2 2- 105