HP Surestore 28/48-Slot with DLT7000 Digital Linear Tape SCSI-2 Drive and SCSI - Page 55

NOTE Library SCSI-3 Command Set Request Sense Command (03H) SKSV When set to 1, the Sense Key Specific bytes (Bytes 15, 16, and 17) contain valid data. When set to 0, Bytes 15, 16, and 17 are 0. C/D 1 = Illegal Parameter is in Command Descriptor Block. 0 = Illegal Parameter is in Data Out Phase. BPV 1 = Bit pointer field is valid. 0 = Bit pointer field is invalid. Bit Pointer Specifies which bit is in error. When a multiple bit field is in error, the pointer points to the most significant bit in the field. Field Pointer Specifies which byte is in error. Bytes are numbered starting from 0. When a multiple-byte field is in error, the pointer points to the most significant byte of the field. Bytes identified as being in error are not necessarily the bytes that need to be changed to correct the problem. Additional Sense Bytes This field may contain information when the Additional Sense Length field contains a value greater than 10. See Table 3-3 on page 3-9. Chapter 2 2- 11