JVC KY-F70BU Instruction Manual - Page 25
Connecting a printer
View all JVC KY-F70BU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Connecting a printer It is possible to directly output image data stored in the main unit memory to a printer. ( ੬ page 39 Outputting images from the memory to a printer) CAUTION Before connecting, make sure that the power of all systems are turned off. Connecting with the power turned on may result in malfunction. Dip switches Use the following printer. Mitsubishi: CP-700DSU/E, CP-770DW, CP-800DW ALARM SHEET PAPER DATA CP700DSA MITSUBISHI PAPER FEED & CUT ] COPY ONLINE POWER OPEN SCSI REC SEND AW/SEL MODE MENU UP DOWN SET PLAY FREEZE MONITOR LENS REMOTE ON 1 2 3 4 DC IN POWER SEE INSTRUCTION MANUAL SCSI terminal • Be sure to terminate the last device on the SCSI bus. When directly connecting the main unit to a printer, set the dip switches on the rear of the main unit as shown below. ON 1 2 3 4 (ID : 7) CAUTION Set the ID of the printer side to other than 7. MEMO • Turn on the camera power after turning on the printer power. • Connecting two or more printers at the same time is not possible. • The image data outputted to a printer will be 1312 × 1024 pixels, regardless whether the mode is VGA or SXGA, or whether the VGA mode is set to FINE or DRAFT. • The maximum allowed length of the SCSI cable is 3m. • When connecting an MO/Zip® drive to a PC, separate setting of the SCSI ID is required. • It is not possible to simultaneously output the image data to a printer and MO/Zip® drive. E21