JVC KY-F70BU Instruction Manual - Page 43
Outputting images from the memory to a printer
View all JVC KY-F70BU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Outputting images from the memory to a printer Use a compatible printer. (੬ Page 21) It is possible to directly output images stored in the camera's memory to a printer connected via the SCSI terminal when in the FREEZE or PLAY mode. Print confirmation PR I NT OUT ACCE PT SCSI Output mark Number of recordable shots remaining SCSI output image mark PR I NT OUT OK Ⅵ Set to either the FREEZE ( ੬ page 36) or PLAY ( ੬ page 37) mode. 1. Check to make sure that dip switches 1 and 2 are set to OFF as shown in the diagram on the left ( ੬ page 38). 2. Press the SEND button. The data will be sent to the printer and a PRINTOUT ACCEPT message will appear for approximately 3 seconds on the monitor connected to the MONITOR terminal. At this time, SCSI output mark will appear. 3. After data is successfully outputted to the printer, PRINT OUT OK will appear for approximately 3 seconds. 4. If data is not successfully outputted to the printer, one of the following error messages will appear for approximately 3 seconds. ERROR : SCSI (check the cable) ERROR : PRINTER (printer error) Print completed MEMO • Do not turn off the power of the main unit or other connected devices when the SCSI output mark is displayed. • Set the SCSI ID of the MO/Zip® drive or printer to other than 7. • If both MO/Zip® drive and printer are connected to the SCSI terminal, select which source to output to by selecting PRIORITY in the SYSTEM SETTING screen. ( ੬ Page 59; default setting: DISK) • Do not connect devices other than printers MO drives and Zip® drive to the SCSI terminal since correct output will not be achieved. In addition, the connectable number of devices are one printer and one MO drive, or one printer and one Zip® drive. E39