Konica Minolta bizhub 181 NC-503 User Manual - Page 60
key until AUTO or SPECIFY is selected, and, If AUTO was selected
View all Konica Minolta bizhub 181 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Network settings 4 - If fax kit FK-506 is installed 5 In the "NETWORK SETTING" menu, press the [,] or [+] key until "IP ADDRESS SETTING" is selected, and then press the [OK] key. 6 Press the [,] or [+] key until "AUTO" or "SPECIFY" is selected, and then press the [OK] key. - If "AUTO" was selected, the IP address will automatically be obtained from the DHCP server. After the message "ACCEPTED" appears, the "NETWORK SETTING" menu appears again. - If "SPECIFY" is selected, a screen appears, allowing you to specify the IP address. Continue with step 7. - "AUTO" is available only if a DHCP server is on the network. If "AUTO" is selected, it will not be necessary to specify the subnet mask or gateway settings. NC-503 4-9
Network settings
4
NC-503
4-9
–
If fax kit FK-506 is installed
5
In the “NETWORK SETTING” menu, press the [
,
] or [
+
] key until “IP
ADDRESS SETTING” is selected, and then press the [OK] key.
6
Press the [
,
] or [
+
] key until “AUTO” or “SPECIFY” is selected, and
then press the [OK] key.
–
If “AUTO” was selected, the IP address will automatically be ob-
tained from the DHCP server. After the message “ACCEPTED” ap-
pears, the “NETWORK SETTING” menu appears again.
–
If “SPECIFY” is selected, a screen appears, allowing you to specify
the IP address. Continue with step 7.
–
“AUTO” is available only if a DHCP server is on the network. If “AU-
TO” is selected, it will not be necessary to specify the subnet mask
or gateway settings.