Kyocera FS-C2126MFP FS-C2026MFP/C2126MFP Operation Guide - Page 432

Troubleshooting Symptom Checkpoints Corrective Actions Reference Page Images are skewed. Paper often jams. Printouts are wrinkled. Cannot print. Documents are printed improperly. While the operation panel was being used, the keys locked up and do not respond when pressed. Are the originals placed correctly? Is the paper loaded correctly? Is the paper loaded correctly? Is the paper of the supported type? Is it in good condition? Is the paper curled, folded or wrinkled? Are there any loose scraps or jammed paper in the machine? Is the paper damp? Is the paper set in a proper orientation? Is the machine plugged in? Is the machine powered on? Is the printer cable or network cable connected? Was the machine powered on before the printer cable was connected? Is the print job paused? Are the application software settings at the PC set properly? Is the operation panel locked? When placing originals on the platen, align them with the original size indicator plates. When placing originals in the document processor, align the original width guides securely before placing the originals. Check the position of the paper width guides. Load the paper correctly. Remove the paper, turn it over, and reload it. Replace the paper with new paper. Remove any jammed paper. Replace the paper with new paper. Change the orientation in which the paper is positioned. Plug the power cord into an AC outlet. Turn on the main power switch. Connect the correct printer cable or network cable securely. Power on the machine after connecting the printer cable. Press [Resume] (the Left Select key) to resume printing. Check that the printer driver and application software settings are set properly. Check the panel lock setting in COMMAND CENTER and change the setting if necessary. 2-43 2-44 2-44 2-26 2-26 2-26 10-16 2-26 - - 2-7 2-5 2-5 2-7 7-18 - KYOCERA COMMAND CENTER Operation Guide 10-4