LG 42CQ610H Setup Guide - Page 47

FTG Mode via CPU (Cont.) Optional Manual Configuration / TV Setup The manual configuration procedures below should only be performed if you do not know the RF channels at the site and need to "Learn" an FTG Configuration file from an LQ630H or CQ610H TV as described on the previous page. Ensure the TV is in Pass-through Mode before you begin. Set Installer Menu Items These steps provide specific instruction only on the Installer Menu items that should be set on an LQ630H or CQ610H TV. Refer to pages 19 to 26 for detailed information on all Installer Menu items. xxLQ630H PTC INSTALLER MENU CPU-CTV 1. Make sure the TV is ON. Then, use the Installer Remote to enter the Installer Menu: Press MENU repeatedly until the on-screen display of the TV setup menus no longer toggles, and then press 9-8-7-6 + OK (Enter). 2. Set Installer Menu item 117 FACT DEFAULT to 001 and press OK (Enter) on the Installer Remote. 000 INSTALLER SEQ 000 UPN 000-000-000-000 ASIC D279 PTC V1.00.013 CPU V3.07.00 This clears all Installer Menu custom settings, the channel lineup, etc. and reloads the factory default settings. The value will change back to 0 after the commercial controller (PTC) has been restored to factory default condition. This step ensures that the TV Channel Memory will be the active channel lineup. 3. Set Installer Menu item 003 BAND/AFC, as appropriate. Typical Installer Menu Note: The Installer Menu header will vary depending on the TV you are setting up. 117 FACT DEFAULT 000 • Broadcast: Set to 000. • HRC: Set to 002. 003 BAND/AFC 001 • CATV: Set to 001 (default). • IRC: Set to 003. 4. Set Installer Menu item 027 HOSPITAL MODE, as appropriate, to select the speaker configuration. 5. Set any other Installer Menu items that affect your TV programming network to the required configuration. For example, enable/disable Aux inputs, set a Start Channel, etc. 027 HOSPITAL MODE 254 Adjust the values for these Installer Menu items. 6. After you have adjusted all Installer Menu item settings as required, press OK (Enter) once on the Installer Remote to save your changes; then, press OK (Enter) again to exit the menu. Run Auto Tuning (Channel Search) Note: In the FTG Configuration file, Logical Channel numbers will automatically be assigned in ascending order, starting with 0 (zero), to the Physical Channels from the TV Channel Map. CHANNEL • Auto Tuning • Manual Tuning • Channel Edit • Channel Label Move Enter Note: Pro:Idiom decryption for encrypted channels will not be enabled unless you use the FTG File Manager to set the channel attributes. 1. Search for all available analog and digital channels: Use the Installer Remote to go to the Channel Menu, select the Auto Tuning option, and follow the on-screen instructions. 2. Use the Channel Edit option in the Channel Menu to edit the channel lineup, as necessary, to include free to guest channels only. Add/delete channels per your system requirements. Use Channel Menu options to run Auto Tuning and edit the channel lineup, as necessary. Once you have completed these procedures, return to "Learning an FTG Configuration File from a TV" on the previous page to complete the Learn sequence. 206-4207 47