Lexmark C520 Service Manual - Page 24

5022-xxx Service error codes and paper jam messages (continued) Error code 200.22 200.25 201.06 201.07 201.08 Description Pick (tray 1) motor stalled. Possible causes: • Faulty cable/connector • Faulty pick motor • Faulty system card Input sensor is made when tray 1 is installed. Possible causes: • Improper placement of paper in tray 1 • Damaged input sensor flag or input sensor • Faulty system card Paper is jammed between the input sensor and the exit sensor. Possible causes: • Damaged paper exit sensor or paper exit sensor flag • Damaged fuser autoconnect • Faulty fuser DC cable connection • Faulty fuser • Faulty system card Exit sensor is made early. Possible causes: • Damaged paper exit sensor or paper exit sensor flag • Damaged fuser autoconnect • Faulty fuser DC cable connection • Faulty fuser • Faulty system card Exit sensor is never made. Possible causes: • Improper loading of manual feed slot • Paper wrapped in fuser • Damaged paper exit sensor or paper exit sensor flag • Damaged fuser autoconnect • Faulty fuser DC cable connection • Faulty fuser • Faulty system card Action • Check for anything in the paper path that might cause the paper to jam. • If clearing a paper jam does not fix the problem, go to "140.xx-Autocomp (tray 1) motor error service check" on page 2-32. • Fan media, and stack flat in the tray or MPF. • Properly set media restraints in the paper tray. • If clearing a paper jam does not fix the problem, go to "Input sensor service check" on page 2-52. • Check for anything in the paper path that might cause the paper to jam. • The fuser exit sensor may not be functioning properly. See "Exit sensor service check" on page 2-52. • Check for anything in the paper path that might cause the paper to jam. • The fuser exit sensor may not be functioning properly. See "Exit sensor service check" on page 2-52. • Check for anything in the paper path that might cause the paper to jam. • Load paper in the manual feed slot. See "Paper jams in the multipurpose feeder or manual feeder" on page 3-28. • The fuser exit sensor may not be functioning properly. See "Exit sensor service check" on page 2-52. Diagnostic information 2-9