Lexmark C520 Service Manual - Page 318

5022-xxx Transfer belt removal See "Transfer belt assembly, C52x" on page 7-15 or "Transfer belt assembly, C53x" on page 7-15 for the part number. 1. Remove all photoconductor units. See "Photoconductor unit removal" on page 4-70. Warning: To avoid damaging the photoconductor drum, hold the photoconductor units by their handle and place the photoconductor units on a clean surface. Never expose the photoconductor units to light for a prolonged period of time. See "Handing the photoconductor unit" on page 4-2 for additional information. 2. Disconnect the transfer belt cable (A). 3. Press the two tabs (B) on either side of the transfer belt assembly, and lift out the transfer belt assembly. Model C52x Model C53x A B A B Installation notes: When you installed the new transfer belt and moved all the photoconductor units from the used one to the new one, the alignment of the toner cartridges and photoconductor units may have changed. For better color quality, perform the Color Alignment procedure in the Configuration Menu. See "Color Alignment" on page 3-24. 1. Enter the Configuration Menu. (Turn off the printer, press and hold release the buttons when the clock graphic displays.) 2. Select Color Alignment. See "Color Alignment" on page 3-24. and , turn on the printer, and Repair information 4-91