Nokia IP390 Installation Guide - Page 37
About IP390 Appliance Network Interface Cards, Four-Port 10/100 Mbps Ethernet Network Interface Card
View all Nokia IP390 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
4 About IP390 Appliance Network Interface Cards This chapter describes the PMC network interface cards (NICs) available for the IP390 appliance and describes how to connect those NICs to your network. The following NICs are covered: Four-Port 10/100 Mbps Ethernet Network Interface Card Two-Port Copper Gigabit Ethernet Network Interface Card Two-Port Fiber-Optic Gigabit Ethernet Network Interface Card Four-Port T1 Network Interface Card For instructions on adding or replacing NICs, see Chapter 5, "Installing and Replacing Network Interface Cards." Caution Protect your IP390 appliance and other electronic equipment from electrostatic discharge (ESD) damage by making sure you are properly grounded before you touch any electronic component. Four-Port 10/100 Mbps Ethernet Network Interface Card The IP390 appliance supports Nokia-approved, four-port UTP5 dual-mode 10-Mbps and 100Mbps Ethernet NICs. When you purchase an Ethernet NIC with your IP390 appliance, the NIC is installed before the appliance is delivered to you. For information on how to add or replace a NIC later, see Chapter 5, "Installing and Replacing Network Interface Cards." Ethernet NIC Features The Ethernet PMC NIC supports the following features: Supports traffic at 10 and 100 Mbps Packet tracing for analysis through tcpdump IP390 Security Platform Installation Guide 37