Nokia IP390 Installation Guide - Page 57

Installing and Replacing Components Other than Network Interface Cards - memory upgrade

Get Nokia IP390 - Security Appliance PDF manuals and user guides View all Nokia IP390 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 57 highlights

6 Installing and Replacing Components Other than Network Interface Cards This chapter provides information on how to install or replace user serviceable items other than network interface cards (NICs) in your IP390 appliance. The following topics are covered: „ Replacing the Compact Flash Memory Card „ Installing a Flash-Memory PC Card „ Installing or Replacing a Hard-Disk Drive „ Replacing or Upgrading Memory „ Replacing the Battery For instructions on adding or replacing interface cards, see Chapter 5, "Installing and Replacing Network Interface Cards". Caution You should have a working knowledge of networking equipment before attempting to service an IP390 appliance. Limit service of the appliance to the procedures described in this chapter. Caution Protect your IP390 appliance and other electronic equipment from electrostatic discharge (ESD) damage by making sure you are properly grounded before you touch any component. Replacing the Compact Flash Memory Card In flash-based IP390 appliances, the compact flash memory card stores the Nokia IPSO operating system, Check Point application, and boot manager. In disk-based IP390 appliances, the compact flash memory card stores only the boot manager, and the Nokia IPSO operating system and Check Point application are stored on the hard-disk drive. Use the internal compact flash to boot the system and install the Nokia IPSO operating system on the disk. The compact flash memory card is located on the motherboard in a slot behind the hard-disk drive location. Figure 21 shows the location of the compact flash memory card. IP390 Security Platform Installation Guide 57

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
IP390 Security Platform Installation Guide
57
6
Installing and Replacing Components
Other than Network Interface Cards
This chapter provides information on how to install or replace user serviceable items other than
network interface cards (NICs) in your IP390 appliance. The following topics are covered:
Replacing the Compact Flash Memory Card
Installing a Flash-Memory PC Card
Installing or Replacing a Hard-Disk Drive
Replacing or Upgrading Memory
Replacing the Battery
For instructions on adding or replacing interface cards, see
Chapter 5, “Installing and Replacing
Network Interface Cards”
.
Caution
You should have a working knowledge of networking equipment before attempting to
service an IP390 appliance. Limit service of the appliance to the procedures described
in this chapter.
Caution
Protect your IP390 appliance and other electronic equipment from electrostatic
discharge (ESD) damage by making sure you are properly grounded before you touch
any component.
Replacing the Compact Flash Memory Card
In flash-based IP390 appliances, the compact flash memory card stores the Nokia IPSO
operating system, Check Point application, and boot manager. In disk-based IP390 appliances,
the compact flash memory card stores only the boot manager, and the Nokia IPSO operating
system and Check Point application are stored on the hard-disk drive. Use the internal compact
flash to boot the system and install the Nokia IPSO operating system on the disk. The compact
flash memory card is located on the motherboard in a slot behind the hard-disk drive location.
Figure 21
shows the location of the compact flash memory card.