Onkyo TX-SV636 Owner Manual - Page 18
RO IO
View all Onkyo TX-SV636 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Connection for multiple-room remote control U.S.A. and Canadian models (Xantech Multiple-Room systems) Do not plug in the power cord until all connections have been made. When making connections through ®, be sure to connect the units as shown in the connection diagram below. Do not make a mistake when connecting the units. A. Operating components displaying Onkyo's R I mark from the sub-room Components mounted in a rack should be connected as shown below to enable remote control operation. MAIN ROOM 1. Onkyo components (a) 3. Connecting TX-SV636 \ block Speaker Main ,\ Speaker Mein (Main room (Main room) \ \\ \ \ Power supply ® SUB ROOM Remote controller 4. Dinky Link or J-Box Receiver 2. Speaker Remote Sub room) 2. Speaker Remote Sub room) 1. Set up the components (a) displaying Onkyo's R I mark. 2. Connect the speaker remote cables to the speaker terminal on the TX-SV636. 0 3. Install Connecting Block 789-40 in the main room, then connect it to the TXSV636. ® (Connect Power Supply 781C-00 to the Connecting Block.) 4. Install Xantech's J-Box Receiver 780-10 or Dinky Link 480B-00 in the sub-room, then connect it to the Connecting Block in the main room. ® B. Using a remote controller to operate components not displaying Onkyo's R I mark from the sub-room 3. Emitter 0 (c) MAIN ROOM 5. Emitter (e) 4. Components(d) 1. Components(b) Speaker Main (Main room) NII \ Connect ng block TX-SV636 \/ ppeaker Main \ (Man room) Power supply SUB ROOM Remote controller Dinky Link or J-Box Receiver \ Speaker Remote (Sub room) Speake) Remote (Sub room) I. Connect the components (b) to the TXSV636. 2. Make the connections described above in steps 2 through 4 of section A. 3. Install Emitter 282-00 (c) so that its sensor is directed toward these components, then connect it to the TX-SV636. ® • Operating components which are positioned out of the range of the emitter installed as described above. 4. Connect the components (d) to the TXSV636. 5. Install another Emitter 282-00 (e) so that its sensor is directed toward these components, then connect it to the Connecting Block 789-40.06 Connection diagram Speaker Main (Main Room) OO O O L 0000 0000 tP.)"'s FRONT © C) C) C) fiR IN@ a OUT/a- gi Green Terminal - SPEAKERS ao (.99 CC V CO 90 O O O O O O O O O © © a, FRONT 00 7 SPEAKERS REMOTE TX-SV636 0 18 Connecting block 789-40 Emitter 282-00 0 Power supply 781C-00 Speaker Remote (Sub room) O O O O O Dinky link 480B-00 or J-Box Receiver 780-10 SUB ROOM