Onkyo TX-SV636 Owner Manual - Page 45

Troubleshooting guide NOTE: The tuning steps by which the tuned frequency changes on each band have been set at the factory to the proper value for the country where each unit is to be sold. If you use the unit in a country where a different tuning step is required or if the broadcast frequencies in your country change so that you can not tune in radio stations precisely, contact your authorized Onkyo Service Center. This device employs a microcomputer to perform various functions and operations. If interference generated by an external power supply, radio waves. or other electrical souce results in an accident which causes the specified operations and functions to operate abnormally. To perform a reset, please follow the procedure below. I. Press and hold down the VIDEO-I button, then press the SPEAKERS MAIN button. 2. After "clear" is displayed, the preset memory and parameters stored in the memory, such as surround, are initialized and will return to the factory settings. Problem with the RC-P101S/P201S remote controller If the remote controller does not operate. • First, try operations using the buttons of the main unit for each function. If operation is not possible, the fault is in the main unit and not the remote controller. • If the batteries are weak, replace the batteries. The codes programed by the button of RC-P101S/P201S have been "forgotten". • If the batteries are taken out of the unit for more than one hour, programed codes will be lost. In this case, please memorize the codes once again. Some or all buttons on the video device do not function. • Depending on the video device manufacturer, some buttons on the remote controller may not work. In this case, use the remote controller that came with the video device. Questions Q: How do I get my remote speaker to turn on? Q: I cannot get On-screen graphics on my TV/Monitor. Q: How do I get just my TV sound through my stereo? Q: Why is there no sound coming from my unit? It worked fine yesterday and there is some music faintly in the background. Answers A: Hit multi-source button, select source (CD, FM) then hit remote speaker button. On hand held remote, hit VOLUME A /V key to send volume to remote speakers. This is independent from the main volume. A: Make sure you have a single RCA video cable running from the monitor out on the back of the Onkyo going to the EXT. 1 or video-1 input of your TV/Monitor. You must make the input selection at the TV/Monitor. (Many customer assume that the Onkyo will switch the TV/Monitor mode automatically.) A: On the back of your TV/Monitor you should see AUDIO OUT left and right RCA jacks. Run a standard RCA cable from those output to any line level input on the Onkyo. Do not use the Phono input. A: Check to see that the TAPE-2 MONITOR button is not engaged. 45