Onkyo TX-SV636 Owner Manual - Page 25

Using preset stations Coo GROUP MEMORY 1-9,0/10 0 C0 PRESET SCAN 9 9. ...0 Preset n channel GRUOP --i- Device Selector 2 MEMORY O MEMORY GROUP 4 1 2-a I OM I am I GROUP I I 2-b PRESET SCAN Cr'4VP!'4 1 7 7- CA8, RECALL 0 GROUP CH Programming radio stations 1. Select the frequency that you want to store in the memory.. ( See Receiving stations on pa).2e 24) 2. Press the MEMORY button. The MEMORY indicator will light for S seconds. 3. While the MEMORY indicator lights, press the GROUP button to choose the desired group. The group shown on the displio, changes in the following order each time the button is pressed: A --» B C A 4. Select the desired memory number using the number buttons. Use the 0110 number hutton to enter a 10. • Since ten AM or FM stations can he stored in each group (A. B or O. a total of 30 stations can he stored in the memory. • If the FM station received is an RDS station with a PS (Program Service Name). the frequency display will change to the PS display. If there is no PS. the frequency display will not change. Refer to page 27 for the RDS function. (RDS function is only for features of European model.) Recalling preset stations 1. Press the GROUP button to select the desired group. 2-a. Input the memory number you wish to receive by using the number buttons. 2-b. Press the PRESET SCAN (or SCAN) button. Each station stored in the group chosen in step I will he recei'ied for 5 seconds (for each station )When the station that you want is found. press the PR1lSET SCAN f or SCAN) hutton again and scanning will stop. Use Remote controller Set the device selector switch to the CD/TUNER position. Press the GROUP button and choose the group. Press the CH (up) or (down) button. After the last number of GROUP C is reached. scanning will restart at GROUP A. 25