Onkyo TX-SV636 Owner Manual - Page 41

Setting the surround parameters C.1..4. "li, C0 1.1 , _Ind Se: Lp COLAS Sur .Xode - THEATER THEATER Si ze - 1 SP Sir E?. Image EFF,'T Level E FEE. ", E ezel. 1 [OM ,ERN 'Time 22 EFA:LT m Initial sound reflections COD Reverb Time ON "le•E> HALL Size L I. : Shape EFFS.CT Level i-EVERH Level ESERI, nn .0 M 0 pp . . nn p ouvx-r-k-o, ila I ONKYO Ha 1 A >0.6< >0.8< Explanation 7: Effect level, Reverb level and Reverb time By adjusting the level of the initial reflections and reverberation in sound from a recording, it is possible to create the illusion of actually being in a concert hall or movie theater without leaving your living room. By adjusting the effect level, reverb level and reverb time. it is possible to recreate the sonic environment of a concert hall or movie theater. For each parameter. you can set one of the seven levels between 0.4 and 1 .6. On screen Move the cursor to EFFECT Level (or REVERB Level, or REVERB Time) using A or V cursor button and use the 41 or ► cursor button to adjust the level. Main unit 1. Use the PARAMETER SELECTOR nr b. button to select Effect Level (or Reverb Level or Reverb Time). 2. Use the PARAMETER CONTROLLER t or ► but- ton to adjust the level. A. Effect level: This parameter adjust the initial reflection level. B. Reverb level: This parameter adjust the level of only the reverb (not the initial reflections). Raising the level makes the mountain higher. (Refer to the illustrastion. ) C. Reverb Time: This parameter adjust the time taken for the reverberation to decay completely. Lenghtening the reverb time widens the base of the mountain. Explanation 8: Hail shape Simulates the shape of the concert hall. Seven Hall shape can be selected, from 0.4 to 1.6.0.4 to 0.8 simulates rectangular shapes, 1 .0 simulates a square shape and 1.2 to 1 .6 simulate oblong shapes. The number is the ratio of hall breadth to length. On screen Move the cursor to Sur. Mode using A or V cursor button and use the 4 or 10- cursor button to select HALL. Move the cursor on HALL Shape using A or V cursor button and use the 4 and O. cursor buttons to select the value. Main unit I. Use the PARAMETER SELECTOR 4 or ► button to select Hall Shape. 2. Use the PARAMETER CONTROLLER -4 or ► but- ton to alter the hall shape. ONKYO Szape >1.2< >1.4< (r 7,3 DeeperMOWider 41