Ricoh 8100DN Software Guide - Page 208
hostname, ifconfig, View settings, IPv4 Configuration
UPC - 026649025952
View all Ricoh 8100DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 208 highlights
Monitoring and Configuring the Printer hostname Use the "hostname" command to change the printer name. ❖ View settings msh> hostname ❖ IPv4 Configuration msh> hostname "interface_name " "printer_name" • Enter the printer name using up to 63 alphanumeric characters. • You cannot use a printer name starting with "RNP" or "rnp". • The Ethernet interface and IEEE 802.11b interface will have the same printer name. • wlan can be specified only when the IEEE 802.11b interface unit and the optional SDRAM module are installed. 5 Interface name Interface configured ether Ethernet interface wlan IEEE 802.11b interface ❖ Initializing the printer name for each interface msh>hostname "interface_name" clear "name" ifconfig Use the "ifconfig" command to view and configure TCP/IP (IP address, subnet mask, broadcast address, default gateway address) for the printer. ❖ View settings msh> ifconfig ❖ IPv4 Configuration msh> ifconfig "interface_name" "parameter" "address" • If you did not enter an interface name, it is automatically set to the Ethernet interface. • wlan can be specified only when the IEEE 802.11b interface unit and the optional SDRAM module are installed. Interface name ether wlan Interface configured Ethernet Interface IEEE 802.11b Interface The following explains how to configure an IPv4 address 192.168.15.16 on Ethernet interface. 196 msh> ifconfig ether 192.168.15.16