Ricoh 8100DN Software Guide - Page 220
Remote Configuration Authorization configuration, SNMP TRAP configuration
UPC - 026649025952
View all Ricoh 8100DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 220 highlights
Monitoring and Configuring the Printer ❖ Access configuration msh> snmp "number" {ipv4|ipv6|ipx} "address" • You can configure a host address according to the protocol used. • The network interface board accepts requests only from hosts that have IPv4, IPv6, and IPX addresses with access types of "read-only" or "readwrite". Enter "0" to have network interface board accept requests from any host without requiring a specific type of access. • Enter a host address to deliver "trap" access type information to. • To specify IPv4 or IPv6, enter "ipv4" or "ipv6" followed by a space, and then the IPv4 or IPv6 address. • To specify IPX/SPX, enter "ipx" followed by a space, the IPX address followed by a decimal, and then the MAC address of the network interface board. ❖ sysLocation configuration 5 msh> snmp location ❖ Deleting sysLocation msh> snmp clear location ❖ sysContact setting msh> snmp contact ❖ Deleting sysContact msh> snmp clear contact ❖ SNMP v1v2 function configuration msh> snmp v1v2 {on|off} • Specify "on" to enable, and "off" to disable. ❖ SNMP v3 function configuration msh> snmp v3 {on|off} • Specify "on" to enable, and "off" to disable. ❖ SNMP TRAP configuration msh> snmp trap {v1|v2|v3} {on|off} • Specify "on" to enable, and "off" to disable. ❖ Remote Configuration Authorization configuration msh> snmp remote {on|off} • Specify "on" to enable, and "off" to disable the SNMP v1v2 setting. 208