Ricoh 8100DN Software Guide - Page 222
spoolsw, Interval configuration, Time-zone configuration, View settings, Job Spool setting
UPC - 026649025952
View all Ricoh 8100DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 222 highlights
Monitoring and Configuring the Printer ❖ Interval configuration msh> sntp interval "polling_time" • You can specify the interval at which the printer synchronizes with the operator-specified NTP server. The default is 60 minutes. • The interval can be entered from 0, or between 16 and 10,080 minutes. • If you set 0, the printer synchronizes with the NTP server only when you turn the printer on. After that, the printer does not synchronize with the NTP server. ❖ Time-zone configuration msh> sntp timezone "+/-hour_time" • You can specify the time difference between the printer clock and NTP server clock. The values are between -12:00 and +13:00. spoolsw 5 Use the "spoolsw" command to view and configure Job Spool settings. You can only specify diprint, lpr, ipp, ftp, smband sftp protocol. • The "spoolsw" command for configuring Job Spool settings is available only when the optional hard disk is installed. ❖ View settings The Job Spool setting appears. msh> spoolsw ❖ Job Spool setting msh> spoolsw spool {on | off} Note ❒ Specify "on" to enable Job Spool, or "off" to disable it. ❖ Resetting Job spool setting msh> spoolsw clear job {on | off} • When the printer power is cut during job spooling, this determines whether to reprint the spooled job. ❖ Protocol configuration msh> spoolsw diprint {on | off} msh> spoolsw lpr {on | off} msh> spoolsw ipp {on | off} msh> spoolsw smb {on | off} msh> spoolsw ftp {on | off} msh> spoolsw sftp {on|off} • You can specify the settings for diprint, lpr, ipp, smb and sftp. 210