Ricoh 8100DN Software Guide - Page 219

Remote Maintenance by telnet ❖ Community name configuration msh> snmp "number" name "community_name" • You can configure ten SNMP access settings numbered 1-10. • The printer cannot be accessed from SmartDeviceMonitor for Admin or SmartDeviceMonitor for Client if "public" is not registered in numbers 110. When changing the community name, use SmartDeviceMonitor for Admin and SNMP Setup Tool to correspond with printer settings. • The community name can be entered using up to 15 characters. ❖ Deleting community name msh> snmp "number" clear name ❖ Access type configuration msh> snmp "number" type "access_type" Access type Type of access permission no not accessible 5 read read only write read and write trap user is notified of trapmessages ❖ Protocol configuration msh> snmp {ipv4|ipv6|ipx} {on|off} • Use the following command to set protocols "active" or "inactive": If you set a protocol "inactive", all access settings for that protocol are disabled. • Specify "ipv4" for IPv4, "ipv6" for IPv6, or "ipx" for IPX/SPX. • {on} means "active" and {off} means "inactive". • All protocols cannot be turned off concurrently. ❖ Configuration of protocol for each registration number msh> snmp "number" active {ipv4|ipv6|ipx} {on|off} • To change the protocol of access settings, use the following command. However, if you have disabled a protocol with the above command, activating it here has no effect. 207