Samsung SC-D366 User Manual (ENGLISH) - Page 98

Troubleshooting, Resolución de problemas

Page 98 highlights

ENGLISH Troubleshooting ESPAÑOL Resolución de problemas Troubleshooting ✤ Before contacting a Samsung authorized service center, perform the following simple checks. They may save you the time and expense of an unnecessary call. Resolución de problemas ✤ Antes de ponerse en contacto con un centro de servicio autorizado de Samsung, realice las siguientes comprobaciones. Es posible que le ahorren el tiempo y el coste de una llamada innecesaria. Self Diagnosis Display Pantalla de autodiagnósticos Display Blinking Informs that... Action slow the Battery pack is almost discharged. Change to a charged one. Tape end! slow When the remaining time on the tape is about 2 minutes. Prepare a new one. Tape end! no the tape reached its end. Change to a new one. No Tape! slow there is no tape in Camcorder. Insert a tape. Protection! slow the tape is protected from recording. If you want to record, release the protection. ....D slow the Camcorder has some mechanical fault. L C R 1. Eject the tape. 2. Set to OFF. 3. Detach the battery. 4. Reattach the battery. * If unresolved contact your local samsung service center. slow moisture condensation has formed in the Camcorder. see below. Moisture Condensation ■ If the Camcorder is brought directly from a cold place to a warm place, moisture may condense inside the Camcorder, on the surface of the tape, or on the lens. In this condition, the tape may stick to the head drum and be damaged or the unit may not operate correctly. To prevent possible damage under these circumstances, the Camcorder is fitted with a moisture sensor. ■ If there is moisture inside the Camcorder, (DEW) is displayed. If this happens, none of the functions except cassette ejection will work. Open the cassette compartment and remove the Battery. Leave the Camcorder for at least two hours in a dry warm room. 98 Pantalla Parpadeo Indica que... Posible solución Tape end! Tape end! No Tape! Lento Lento No Lento la batería está casi descargada. el tiempo restante de grabación es de unos dos minutos. la cinta ha llegado al final. no hay cinta en la videocámara. Reemplácela por una cargada. Prepare una cinta nueva. Cámbiela por una nueva. Inserte una cinta. Protection! ....D L C R Lento Lento la cinta está protegida contra grabación. la videocámara tiene algún fallo mecánico. Lento se ha condensado humedad en la videocámara. Si desea grabar, libere la protección. 1. Saque la cinta. 2. Apague la videocámara. 3. Quite la batería. 4. Ponga de nuevo la batería. * Si no puede resolver el problema, póngase en contacto con el centro de servicio de Samsung. Ver más abajo. Condensación de humedad ■ Si se lleva la videocámara directamente de un lugar frío a uno cálido, se puede condensar la humedad dentro de ella, en la superficie de la cinta o en el objetivo. En estas condiciones, la cinta puede adherirse a los cabezales y estropearse o puede que el aparato no funcione correctamente. Para prevenir posibles daños bajo estas circunstancias, la videocámara está dotada con un sensor de humedad. ■ Si hay humedad dentro de la videocámara, aparecerá en la pantalla la señal (DEW). Si esto sucede, ninguna de las funciones de la videocámara estará operativa, excepto la de expulsión de la cinta. Abra el compartimento del casete y quite la batería. Deje la videocámara durante al menos dos horas en un lugar seco y templado.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106

ENGLISH
ESPAÑOL
98
98
Troubleshooting
Resolución de problemas
Troubleshooting
Before contacting a Samsung authorized service center, perform the
following simple checks.
They may save you the time and expense of an unnecessary call.
Self Diagnosis Display
Moisture Condensation
If the Camcorder is brought directly from a cold place to a warm
place, moisture may condense inside the Camcorder,
on the surface of the tape, or on the lens. In this condition, the tape
may stick to the head drum and be damaged or the unit may not
operate correctly.
To prevent possible damage under these circumstances, the
Camcorder is fitted with a moisture sensor.
If there is moisture inside the Camcorder,
(DEW) is displayed.
If this happens, none of the functions except cassette ejection will
work.
Open the cassette compartment and remove the Battery.
Leave the Camcorder for at least two hours in a dry warm room.
slow
slow
no
slow
slow
slow
slow
the Battery pack is almost discharged.
Change to a charged one.
When the remaining time on the
tape is about 2 minutes.
Prepare a new one.
the tape reached its end.
Change to a new one.
there is no tape in Camcorder.
Insert a tape.
the tape is protected from recording.
If you want to record,
release the protection.
moisture condensation has formed
in the Camcorder.
see below.
the Camcorder has some
mechanical fault.
1. Eject the tape.
2. Set to OFF.
3. Detach the battery.
4. Reattach the battery.
* If unresolved contact your
local samsung service center.
Tape end!
Tape end!
No Tape!
Protection!
....
D
L
C
R
Display
Blinking
Informs that...
Action
Resolución de problemas
Antes de ponerse en contacto con un centro de servicio autorizado
de Samsung, realice las siguientes comprobaciones.
Es posible que le ahorren el tiempo y el coste de una llamada innecesaria.
Pantalla de autodiagnósticos
Condensación de humedad
Si se lleva la videocámara directamente de un lugar frío a uno cálido, se
puede condensar la humedad dentro de ella, en la superficie de la cinta o en
el objetivo. En estas condiciones, la cinta puede adherirse a los cabezales y
estropearse o puede que el aparato no funcione correctamente.
Para prevenir posibles daños bajo estas circunstancias, la videocámara
está dotada con un sensor de humedad.
Si hay humedad dentro de la videocámara, aparecerá en la pantalla
la señal
(DEW).
Si esto sucede, ninguna de las funciones de la videocámara estará
operativa, excepto la de expulsión de la cinta.
Abra el compartimento del casete y quite la batería.
Deje la videocámara durante al menos dos horas en un lugar seco y
templado.
Lento
Lento
No
Lento
Lento
Lento
Lento
la batería está casi descargada.
Reemplácela por una cargada.
el tiempo restante de grabación es
de unos dos minutos.
Prepare una cinta nueva.
la cinta ha llegado al final.
Cámbiela por una nueva.
no hay cinta en la videocámara.
Inserte una cinta.
la cinta está protegida contra
grabación.
Si desea grabar, libere la
protección.
se ha condensado humedad en la
videocámara.
Ver más abajo.
la videocámara tiene algún fallo
mecánico.
1. Saque la cinta.
2. Apague la videocámara.
3. Quite la batería.
4. Ponga de nuevo la batería.
*
Si no puede resolver el problema,
póngase en contacto con el centro
de servicio de Samsung.
Tape end!
Tape end!
No Tape!
Protection!
....
D
L
C
R
Pantalla
Parpadeo
Indica que...
Posible solución