Sharp AR-M205 AR-M160 AR-M205 Operation Manual - Page 18

BEFORE USING THE MACHINE Envelopes Do not use the following envelopes, as misfeeds will occur. • Envelopes with metal tabs, clasps, strings, holes, or windows. • Envelopes with rough fibers, carbon paper, or glossy surfaces. • Envelopes with two or more flaps. • Envelopes with tape, film, or paper attached to the flap. • Envelopes with a fold in the flap. • Envelopes with glue on the flap to be moistened for sealing. • Envelopes with labels or stamps. • Envelopes that are slightly inflated with air. • Envelopes with glue protruding from the seal area. • Envelopes with part of the seal area peeled off. CHANGING A TRAY'S PAPER SIZE SETTING Follow these steps to change a tray's paper size setting. Note • The paper size setting cannot be changed when the machine has stopped temporarily due to running out of paper or a misfeed, or during interrupt copying. • During printing (even in copy mode), the paper size setting cannot be changed. • 5-1/2" x 8-1/2" size paper can only be selected in upper paper tray. • Do not load paper that is a different size than the paper size setting. Copying will not be possible. 1 Hold down the [PAPER SIZE ENTER] key for more than 5 seconds to set the selected paper size. GINAL PAPER SIZE 11X17 8½X14 8½X11 8½X5½ 8½X11 EXTRA The currently selected paper feed location indicator will blink and the corresponding paper size (which is currently set) indicator will light steadily. All other indicators will go out. 3 Use the [ORIGINAL SIZE ENTER] key to select the paper size. GINAL PAPER SIZE ORIGINAL SIZE ENTER 11X17 8½X14 8½X11 8½X5½ 8½X11 EXTRA The indicator of the selected paper size lights up. 2 Use the [TRAY SELECT] key ( ) to select the paper tray for which you wish to change the paper size setting. TRAY SELECT Each time the [TRAY SELECT] key ( ) is pressed, a paper tray will be indicated with a blinking paper feed location indicator. 16