Sharp AR-M205 AR-M160 AR-M205 Operation Manual - Page 58
Printing And Scanning Problems - specifications
View all Sharp AR-M205 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
TROUBLESHOOTING PRINTING AND SCANNING PROBLEMS In addition to this section, troubleshooting information can also be found in the README files for each of the software programs. To view a README file, see the "Software Setup Guide". Problem The machine does not print. (ON LINE indicator does not blink.) The machine does not print. (ON LINE indicator was blinking.) Printing is slow. The printed image is light and uneven. Cause and solution The machine is set to ONLINE mode. → Press the [ON LINE] key to turn on the ON LINE indicator. The machine is not correctly connected with your computer. → Check both ends of the printer cable and make sure you have a solid connection. Try a known good cable. For information on cables, see "SPECIFICATIONS". The port setting is correct. → Printing is not possible if the printer driver port setting is not correct. Set the port correctly. Copy job is performed. → Wait until the copy job is complete. The tray size settings are the same on the machine and in the printer driver. → Make sure that the same tray paper size is set on the machine and in the printer driver. To change the tray paper size setting in the printer driver, see the Software Setup Guide. The specified size of paper has been loaded. → Load the specified size of paper in the paper tray. All paper feed location indicators are blinking. → When "Use close paper size (user program)" is disabled, the PAPER SIZE indicator on the operation panel will blink. You can press the [TRAY SELECT] key ( ) to select a tray manually, or load paper in the bypass tray and press the [ON LINE] key to begin printing. → When "Use close paper size" is enabled, printing will take place using a size of paper that is close to the size of the print image. Simultaneous use of two or more application software programs. → Start printing after quitting all unused application software programs. The paper is loaded so that printing takes place on the front side of the paper. → Some paper types have a front and back side. If the paper is loaded so that printing takes place on the back side, toner will not adhere well to the paper and a good image will not be obtained. Page 39 78 Software Setup Guide - 16 Software Setup Guide 14 14, 21 - - 14 56