Xerox 3300MFP Service Manual - Page 167

Service Parts Disassembly 11. Remove four E-clips, the left Jam Link Lever, the right Jam Link Lever, and two Jam Link Holders, as shown here. Jam Link Lever Jam Holder Jam Link Lever Jam Holder s3300mfp-025 12. Carefully lift the Pressure Roller out of the Fuser frame. Be careful not to drop the pressure bearings, which are loose on the frame. Fuser Reassembly Notes ■ When reinstalling the Jam Link Holders, grasp the assembly so that you can compress the pressure roller springs. Wrap the assembly in a sheet of paper to avoid contaminating the roller surface. ■ When reinstalling the Heat Roller, be sure the bushings are installed correctly. Press on the Jam Link Levers as needed to take the pressure of the Pressure Roller off the Heat Roller. ■ When reinstalling the Fuser Cover, make sure the stripper fingers in the cover are in the "down" position. Install the cover very carefully to prevent the stripper fingers from gouging the Heat Roller surface, or from pivoting up in the wrong position. ■ When reinstalling the halogen lamp, avoid touching the glass with bare hands. Handle the lamp by the metal terminals at the ends. Phaser 3300MFP Service Manual 8-15