Yamaha AW4416 Version2.0 Manual Supplement - Page 12

AW4416 Version 2.0 Manual Supplement If you select a category from the right column of buttons (SCENE MEM.-REMOTE), move the cursor to the column at the far right, and turn the [DATA/JOG] dial to select the content within that category that will be transmitted. SETUP MEM. PGM. TABLE CTL. TABLE SCENE MEM. PATCH LIBRARY CH LIBRARY EQ LIBRARY DYN. LIBRARY EFF. LIBRARY AUTO MIX MIDI REMOTE Category AW4416 settings other than the following items Settings of the MIDI screen PGM ASGN. page Settings of the MIDI screen CTL ASGN. page The specified scene memory The specified patch library The specified channel library The specified EQ library The specified dynamics library The specified effect library The specified automix Settings of the REMOTE screen 01-96 EDIT BUFFER ALL 01-20 ALL 02-64 ALL 41-128 ALL 41-128 ALL 42-128 ALL 1-16 BUFFER ALL REMOTE A- REMOTE B ALL Values - - - Scene number 1-96 Current scene (current mixer settings) All scene memories + current scene Library number 1-20 All patch libraries Library number 2-64 All channel libraries Library number 41-128 All EQ libraries Library number 41-128 All dynamics libraries Library number 42-128 All effect libraries Memory number 1-16 Current automix All automixes + current automix Settings of the REMOTE A (REMOTE A 1-8/9-16 pages) or B (REMOTE B 1-8/9-16 pages) Settings of all pages of the REMOTE screen B REQUEST button When you move the cursor to this button and press the [ENTER] key, a "bulk dump request" message requesting the bulk dump data selected in 1 will be transmitted from the MIDI OUT connector/TO HOST connector/option slot. This button is used when two AW4416 units are connected by their respective MIDI IN/OUT connectors, and you want to copy scene memory or library data from one unit to the other. 4 If you selected a SCENE MEM.-REMOTE button, move the cursor to the numerical box at the right of the button, and use the [DATA/JOG] dial to select the internal settings that you want to transmit. C TRANSMIT button When you move the cursor to this button and press the [ENTER] key, the bulk dump will begin. D INTERVAL This adjusts the interval that will be left between data blocks when bulk data is transmitted. You can set the interval in 1 millisecond units over a range of 0-300 milliseconds (default= 0). 3 Move the cursor to the button for the bulk data that you want to transmit, and press the [ENTER] key. The corresponding button will be turned on, and will be selected for bulk dump. Tip! If you move the cursor to the ALL button located at the lower left of CATEGORY and press the [ENTER] key, all settings that can be bulk-dumped will be selected. 5 Put your MIDI sequencer in record-ready mode. When recording bulk data on your MIDI sequencer, make sure that the MIDI Thru function (sometimes called "Patch Thru" or "MIDI Echo") of your MIDI sequencer is turned off. If this function is on, the bulk data transmitted from the AW4416 will be immediately sent back to the AW4416, causing malfunctions. 12 Version 2.0 Manual Supplement