Yamaha AW4416 Version2.0 Manual Supplement - Page 8

AW4416 Version 2.0 Manual Supplement s MIDI Setup 2 page In this page you can select the port that will be used for MIDI transmission and reception: MIDI OUT/ THRU connectors, TO HOST connector, or option slot. Here you can also select the synchronization messages that will be transmitted to external devices. Tip! In this page, signal routes along which MIDI messages flow are shown by a solid line ( | ), and signal routes along which MIDI messages do not flow are shown by a hollow line ( || ). 3 5 4 1 2 A MIDI/HOST/OPTION switch This selects the port that will be used to transmit/ receive MIDI messages. Move the cursor to this area and press the [ENTER] key to cycle through the following three settings. • MIDI The MIDI IN connector and MIDI OUT/THRU connector will be used. • HOST The TO HOST connector will be used. The transmission speed is set by the TO HOST setting. • OPTION The OPTION I/O slot will be used. Tip! The OPTION setting is valid only if an I/O card that can transmit/receive MIDI messages (such as the mLAN card "MY8-mLAN"; planned for availability in the near future) is installed in option slot 2. MIDI message transmission/reception cannot be performed via option slot 1. B OUT/THRU switch This switches the function of the OUT/THRU connector. Move the cursor to this area and press the [ENTER] key to cycle through the following two settings. • THRU The MIDI messages received at the MIDI IN connector will be retransmitted from the OUT/ THRU connector. • OUT Messages generated within the AW4416 will be transmitted from the OUT/THRU connector. C TO HOST Set the transmission speed of the TO HOST connector according to the type of computer you are using. Move the cursor to the TO HOST connector graphic, and turn the [DATA/JOG] dial to select the transmission speed from the following. Setting Platform PC1 NEC PC-9800/9821 series*1 PC2 MAC IBM PC compatible, NEC PC-9800/9821 series*1 Apple Macintosh series*2 Speed 31.25 kbps 38.4 kbps 31.25 kbps *1 Select PC1 or PC2 according to the driver you are using. *2 Only for models that provide a modem/printer port. On the software you are using, set the clock to "1 MHz." D MTC ON/OFF switch This is an on/off switch for the MTC messages that are sent to the MIDI OUT connector/TO HOST connector/option slot. E MIDI CLK ON/OFF (MIDI Clock on/off) switch This is an on/off switch for the MIDI Clock messages that are sent to the MIDI OUT connector/ TO HOST connector/option slot. 8 Version 2.0 Manual Supplement