2010 Jeep Commander Owner's Manual - Page 111
2010 Jeep Commander Manual
Page 111 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 111 Lane Change Assist Tap the lever up or down once, without moving beyond the detent, and the turn signal (right or left) will flash three times then automatically turn off. High/Low Beam Switch Push the multifunction lever away from you to switch the headlights to high beam. Pull the lever toward you to switch the headlights back to low beam. the ignition switch is turned OFF. Only the headlights will illuminate during this time. Refer to "EVIC - Customer-Programmable Features" in Section 4 to turn this feature "On/Off" or set the time interval. Interior Lights The interior lighting consists of courtesy lights mounted below the instrument panel, reading lights located above the front and rear doors, and a rear cargo light. Opening a door or turning the center of the multifunction lever to Flash-To-Pass the extreme up position will activate all interior courtesy You can signal another vehicle with your headlights by lights. lightly pulling the multifunction lever toward the steering wheel. This will turn on the high beam headlights Courtesy/Reading Lights until the lever is released. Each light can be turned on by pressing the recessed area Headlight Off Delay of the lens. To turn these lights off, press the recessed area There is also a feature that delays turning off the vehicle of the lens a second time. There are also reading lights lights for 0, 30, 60 or 90 seconds after the ignition switch located above the rear doors. Each light can be turned on is turned OFF. To activate the headlight delay, the multifunction lever must be rotated to the "Off" position after 3