2010 Jeep Commander Owner's Manual - Page 132
2010 Jeep Commander Manual
Page 132 highlights
132 UNDERSTANDING THE FEATURES OF YOUR VEHICLE Programming HomeLink Before You Begin If you have not trained any of the HomeLink buttons, erase all channels before you begin training. For optimal training, point the battery end of the handheld transmitter away from the HomeLink . To do this, press and hold the two outside buttons for up to 20 seconds. The EVIC will display "CLEARING 3. Simultaneously, press and hold both the chosen CHANNELS." Release the buttons when the EVIC mes- HomeLink button and the hand-held transmitter button until the EVIC display changes from "CHANNEL # sage states "CHANNELS CLEARED." TRAINING" to "CHANNEL # TRAINED." It is recommended that a new battery be placed in the hand-held transmitter of the device being programmed Then release both the HomeLink and hand-held transto HomeLink for more efficient training and accurate mitter buttons. transmission of the radio-frequency signal. If the EVIC display states "DID NOT TRAIN" repeat Your vehicle should be parked outside of the garage Step 3. If the signal is too weak, replace the battery in the while training. original hand-held transmitter. 1. Turn the ignition switch to the ON/RUN position. It may take up to 30 seconds, or longer in rare cases. The garage door may open and close while you train. 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) from the HomeLink buttons while keeping the EVIC display in view.