2010 Jeep Commander Owner's Manual - Page 169

UNDERSTANDING YOUR INSTRUMENT PANEL 169 see your authorized dealer for service as soon as possible. 21. Shift Lever Indicator The Shift Lever Indicator is self-contained within the If the light is flashing when the engine is running, instrument cluster. It displays the gear position of the immediate service is required and you may experience automatic transmission. reduced performance, an elevated/rough idle or engine stall and your vehicle may require towing. The light will NOTE: You must apply the brakes before shifting from come on when the ignition is first turned on and remain PARK. on briefly as a bulb check. If the light does not come on during starting, have the system checked by an autho22. Fuel Gauge The pointer shows the level of fuel in the fuel tank when rized dealer. the ignition switch is in the ON position. 24. Front Fog Light Indicator - If Equipped This indicator will illuminate when the front fog 23. Electronic Throttle Control (ETC) Warning Light This light informs you of a problem with the lights are on. Electronic Throttle Control (ETC) system. If a 25. Charging System Light problem is detected, the light will come on This light shows the status of the electrical chargwhile the engine is running. Cycle the ignition ing system. The light should come on when the key when the vehicle has completely stopped, and the ignition switch is first turned ON and remain on briefly shift lever is placed into the PARK position. The light as a bulb check. If the light stays on or comes on while should turn off. If the light remains lit with the engine driving, turn off some of the vehicle's non-essential running, your vehicle will usually be drivable; however, 4