2010 Jeep Commander Owner's Manual - Page 198
2010 Jeep Commander Manual
Page 198 highlights
198 UNDERSTANDING YOUR INSTRUMENT PANEL to seek up and the left switch to seek down. The radio will remain tuned to the new station until you make NOTE: The ignition switch must be in the ON or ACC another selection. Holding either button will bypass position to operate the radio. stations without stopping until you release it. Power Switch/Volume Control (Rotary) Voice Recognition System (Radio) - If Equipped Push the ON/VOLUME control knob to turn on the Refer to "Voice Recognition (VR)" in the uconnect™ User radio. Push the ON/VOLUME control knob a second Manual located on the DVD for further details. time to turn off the radio. Voice Recognition Button uconnect™ phone - If Electronic Volume Control Equipped The electronic volume control turns continuously (360 Press this button to operate the uconnect™ phone feature degrees) in either direction without stopping. Turning the (if equipped). Refer to "Voice Recognition (VR)" in the ON/VOLUME control knob to the right increases the uconnect™ User Manual located on the DVD for further volume and to the left decreases it. details. When the audio system is turned on, the sound will be If your vehicle is not equipped with or this feature is not set at the same volume level as last played. available on your vehicle, a "Not Equipped With SEEK Buttons UConnect" message will display on the radio screen. Press and release the SEEK buttons to search for the next listenable station in AM/FM mode. Press the right switch Operating Instructions - Radio Mode