2010 Jeep Commander Owner's Manual - Page 175
2010 Jeep Commander Manual
Page 175 highlights
UNDERSTANDING YOUR INSTRUMENT PANEL 175 • MANUAL CLOSE TO OPERATE (Power Liftgate indicator system is duty cycle based, which means the engine oil change interval may fluctuate dependent upon Models Only) your personal driving style. • VEHICLE NOT IN PARK Unless reset, this message will continue to display each • IGNITION POSITION time you turn the ignition switch to the ON/RUN position. To turn off the message temporarily, press and • PRESS BRAKE TO START release the MENU button. To reset the oil change indica• INSERT KEY tor system (after performing the scheduled maintenance) refer to the following procedure. • TURN TO ON • ECO - Fuel Saver Indicator Engine Oil Change Indicator System Oil Change Required Your vehicle is equipped with an engine oil change indicator system. The "Oil Change Required" message will flash in the EVIC display for approximately 10 seconds after a single chime has sounded to indicate the next scheduled oil change interval. The engine oil change 1. Turn the ignition switch to the ON position (Do not start the engine). 2. Fully depress the accelerator pedal slowly three times within 10 seconds. 3. Turn the ignition switch to the OFF/LOCK position. NOTE: If the indicator message illuminates when you start the vehicle, the oil change indicator system did not reset. If necessary repeat this procedure. 4