2010 Jeep Commander Owner's Manual - Page 115

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 115 delay interval. The delay can be regulated from a maxi- Rain Sensing Wipers - If Equipped mum of approximately 18 seconds between cycles, to a This feature senses moisture on the windshield and automatically activates the wipers for the driver. The cycle every 1/2 second. feature is especially useful for road splash or overspray from the windshield washers of the vehicle ahead. Rotate the end of the multifunction lever to one of five settings to activate this feature. The sensitivity of the system can be adjusted with the multifunction lever. Wiper delay position 1 is the least sensitive, and wiper delay position 5 is the most sensitive. Setting 3 should be used for normal rain conditions. Settings 1 and 2 can be used if the driver desires less wiper sensitivity. Settings 4 and 5 can be used if the driver desires more sensitivity. Place the wiper switch in the OFF position when not using the system. 3 Front Wiper Control NOTE: The wiper delay times depend on vehicle speed. NOTE: If the vehicle is moving less than 10 mph (16 km/h), • The Rain Sensing feature will not operate when the wiper switch is in the low or high-speed position. delay times will be doubled.