2010 Jeep Commander Owner's Manual - Page 278
2010 Jeep Commander Manual
Page 278 highlights
278 STARTING AND OPERATING mode is overcome, turn ESP back on by momentarily mode, described above. When the vehicle speed drops pressing the "ESP OFF" switch. This may be done while below 35 mph (56 km/h), the ESP system shuts off. ESP is deactivated at low vehicle speeds so that it will not the vehicle is in motion. interfere with off-road driving, but ESP function returns Full Off (Four-Wheel Drive Models Only) to provide the stability feature at speeds above 40 mph This mode is intended for off-highway or off-road use (64 km/h). The "ESP/TCS Indicator Light" will always when ESP stability features could inhibit vehicle maneube illuminated when ESP is off. To turn ESP on again, verability due to trail conditions. This mode is entered by momentarily press the "ESP OFF" switch. This will pressing and holding the "ESP OFF" switch for five restore the normal "ESP On" mode of operation. seconds when the vehicle is stopped and the engine is running. After five seconds, the "ESP/TCS Indicator NOTE: The "ESP OFF" message will display, and the Light" will illuminate, and the "ESP OFF" message will audible chime will sound, when the shift lever is placed appear in the Electronic Vehicle Information Center in the PARK position from any other position, and then (EVIC). Refer to "Electronic Vehicle Information Center moved out of the PARK position. This will occur even if (EVIC)" in Section 4 of this manual for more information. the message was previously cleared. In this mode, ESP and TCS, except for the "limited slip" feature described in the TCS section, are turned off until the vehicle reaches a speed of 40 mph (64 km/h). At 40 mph (64 km/h), the system returns to "Partial Off"