2010 Jeep Commander Owner's Manual - Page 382

382 MAINTAINING YOUR VEHICLE Selection of Lubricant Use only the manufacturer's recommended fluid. Refer to "Fluids, Lubricants, and Genuine Parts" in this section for the correct fluid type. Transfer Case Drain First remove fill plug, then remove drain plug. Recommended tightening torque for drain and fill plugs is 15 to 25 ft lbs (20 to 34 N·m). CAUTION! Fluid Level Check When installing plugs, do not overtighten. You could Inspect the transfer case for fluid leaks. If a fluid leak is damage them and cause them to leak. found, the transfer case fluid level can be checked by removing the filler plug located on the back side of the Selection of Lubricant transfer case. The fluid level should be at the bottom edge Use only the manufacturer's recommended fluid. Refer of the filler plug hole when the vehicle is in a level to "Fluids, Lubricants, and Genuine Parts" in this section position. for the correct fluid type. Adding Fluid Add fluid at the filler hole, until it runs out of the hole, when the vehicle is in a level position.